The EP Greenhouse gear motor is a compact and lightweight reduction gearbox with an integrated limit switch system that is ideal for assembly of a locally available electric electric motor. The gear motor is utilized in manually-managed or climate-controlled ventilation and display systems in greenhouses. The quick and easy-to-install EP gear motor can be rainproof and 
windproof. The geared motor includes a high protection class (IP65) and can be used in an ambient temperature of 0-60 °C.
The low-noise gear reducer for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated within an aluminum precision housing. The self-braking worm wheel transmission means that the drive shaft can be locked when the decrease reducer is not running. The fully sealed reduction gear reducer comes with an growth chamber with a diaphragm to keep the gear oil at a minimal pressure under all situations, even at high temperatures. Thanks to the use of an growth chamber, the gear driver could be installed in any position. There are no restrictions, because there is no need for a bleed plug. The sealed reduction geared motor keeps the gear oil of the gear reducer in optimal condition for its entire operating lifetime. The gear motor is suitable for discontinuous use, operating course s3-30%, with a maximum activation time of 25 minutes.
The Gear box reduction reducer comes with an FT85 motor assembly flange, on to which a suitable IEC standard motor can simply be installed (EN 50347).
The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit switch system is installed within an built-in chamber and is usually enclosed by an impact-resistant plastic cover. The limit switch system is obtainable and simple to adjust. The limit switch system's optimum switching range is certainly 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The geared motor has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.
The gear reducer for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.
Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temps of 0-60°C.
Ideal for discontinuous use, operating class s3-30%, optimum activation time 25 a few minutes.
Equipped as standard with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).