Massey Ferguson 041682T1 / 22 cc Tractor Hydraulic Gear Pump Replacement

Model identity and its limits

The catalogue associates this assembly with 041682T1. It is a sourcing reference rather than a controlled installation drawing, so no unlisted dimensions are presumed.

No specific tractor serial ranges are established here for 041682T1 / 22 cc. Use the parts manual and existing hardware to complete the application check.

Technical specifications

A fitter’s pre-installation check

Rotation is specified as clockwise for 041682T1 / 22 cc. The sign of this dimension is decisive even when the housing and gear-drive arrangement appear nearly identical.

The feed port is shown as G1; the discharge port as 7/8-24 UNF 2B. Confirm the fitting seat and whether the opening is measured as a bore or a thread.

Correcting a size mismatch

The 22 ml/rev figure represents swept volume, not a constant litres-per-minute delivery. For a correct substitute, ask whether the hydraulic equipment was designed around the same shaft-speed band.

Within the comparison set, MF375 lists 6.2 ml/rev and 175 bar. That is a useful limit check for the 041682T1 / 22 cc hydraulic request, not permission to alter the tractor’s original pump rating.

Flow-control behavior is not defined by this parts entry. Confirm the tractor valve and circuit characteristics independently.

The stated speed is 250–2500 rpm. Before commissioning, verify the engine accessory drive ratio and that normal operating conditions do not exceed this listing.

Practical installation sequence

Cleanliness is particularly important while servicing 041682T1 / 22 cc. Keep the hydraulic ports capped and check for swarf or grit in the suction line; contamination can damage a replacement before its first working cycle.

Correct relief protection and uncontaminated oil matter more than the appearance of the replacement housing.

Same family, different pump

The adjacent Massey Ferguson MF375 part has direction CCW, while 041682T1 / 22 cc is CW. Rotation is a hard constraint even if two supplier listings show comparable capacities.

Wrong-hand selection is a frequent avoidable risk when several variants share an external form.

Complete the pump identification

Quote the complete cross-reference 041682T1 and include the existing pump’s mounting view. If there is an unusual fitting, supply a close-up with a ruler or a thread gauge reading.

Please highlight any change from the original connection standard to avoid quotation assumptions.

Before you approve a replacement

Can I order 041682T1 / 22 cc using just an equipment model number?

It is better to provide the original pump marking and photos, especially when a tractor has had earlier repairs or modifications.

Is the unlisted L/min controlled-flow value the total pump flow?

No controlled-flow entry is printed for this product.

Ordering, samples and shipping terms

Order quantities are set according to pump type and total order value. A small order of 1–2 pieces can be considered at a higher unit price; new customers may request 1–5 samples when the item is suitable. Mixed-model orders are available, normally with a combined order value of approximately USD 1,500.

Typical production schedules are 10–25 working days for standard items, 20–45 working days for customized components, and 45–120 working days for project equipment. Usual delivery terms are EXW, FOB, CIF and DAP. FCA, CFR, CPT, CIP and DDP can be discussed for specific shipments. Confirm the final schedule and terms with the quotation.