In the family of reducers, planetary reducers are widely used in servo, stepping, DC and other transmission systems because of their small size, high transmission efficiency, wide deceleration vary and high precision. Its role is to lessen the speed boost torque and reduce the load/motor moment of inertia ratio beneath the premise of making sure precision transmission. Previously couple of years, some users have suffered from unnecessary damage when the PTO Drive Shaft reducer can be broken due to human factors such as illegal installation. Therefore, to be able to better help the users to utilize the reducer, I will introduce you at length how to correctly install the planetary reducer.
Proper installation, make use of and maintenance of the reducer is an important part of ensuring the normal operation of mechanical equipment. Consequently, when installing the planetary reducer, make sure to thoroughly assemble and utilize it in rigorous accordance with the following installation and use.
First step
Before installation, confirm whether the motor and reducer are intact, and strictly check if the dimensions of the parts connected to the reducer are matched. Listed below are the dimensions and matching tolerances of the positioning boss, insight shaft and reducer groove of the motor.
Second step
Unscrew the screw on the outer side of the flange of the reducer flange, modify the clamping band of the PCS program so that the side holes are aligned with the dust holes, and insert the hexagon socket into the hexagon. After that, take away the motor shaft key.
third step
Connect the electric motor to the gearbox naturally. When connecting, it should be ensured that the output shaft of the reducer 
In addition, it really is strictly forbidden to hit with a hammer or the like during installation to prevent damage to the bearing or gear due to excessive axial force or radial force. Be sure to tighten the mounting bolts before tightening the tightening bolts. Before installation, clean the anti-rust oil of the motor input shaft, positioning boss and reducer reference to gasoline or zinc-sodium drinking water. Its purpose is usually to guarantee the tightness of the bond and the flexibility of operation, and also to prevent unnecessary wear.
Before connecting the motor to the reducer, the motor shaft keyway should be perpendicular to the tightening bolt. To make sure uniform drive, first screw the mounting bolts at any diagonal position, but do not tighten them. Then screw on the mounting bolts at the other two diagonal positions and finally tighten the four mounting bolts one by one. Finally, tighten the tightening bolts. All tightening bolts should be fixed and inspected using the torque wrenches based on the indicated set torque data.
The correct installation between your reducer and the mechanical equipment is comparable to the correct installation between your reducer and the drive motor. The main element is to make sure that the result shaft of the reducer is concentric with the shaft of the powered part.
